Construction
Advanced formula SikaDamp© 630 Peel & Stick Sound Deadener (part 90934) is a simple and effective way to muffle noisy pipes, sewage lines and other conduits. The thin, flexible sheets are perfect for houses, apartments and office buildings. They can be cut to size and molded to any shape. Each peel and stick sheet is 24 inches by 12 inches. Click here for application instuctions.
As a general rule, metal or plastic surfaces may be suitable for SikaDamp 630 Peel & Stick Sound Deadener. Listed below are common damping situations.
Email UsCall 206-783-1696 to Order SikaDamp© 630 We Ship Nationwide Email Us
Soundproof Water Pipes & Drainage Pipes
Noisy pipes are annoying and embarrassing. The sound of rushing water from an upstairs shower can interrupt an afternoon nap. Rattling pipes make your house sound cheap. And nobody wants their Thanksgiving dinner spoiled by the sound of a toilet flush followed by the rush of effluent in the pipes behind the wall.
SikaDamp 630 sound dampening sheets prevent these problems.
The construction industry loves SikaDamp 630 Peel & Stick Sound Deadener. It's an easy way to reduce noise in pipes, sewage lines and other conduits. The aluminum foil peel and stick sheets are thin and flexible. They can be cut to size and molded to any shape.
Better yet, SikaDamp 630 sheets stick to almost any surface. The peel strength of SikaDamp 630 easily outperforms conventional felted asphalt dampers. The super adhesion and conformability of SikaDamp 630 Peel & Stick Sound Deadener results in maximum surface contact, critical for high performance damping.
How to Soundproof Conduits with SikaDamp 630 Peel & Stick Sound Deadener
-
Without removing SikaDamp's protective backing, align a sheet lengthwise along the pipe. Wrap it around the pipe.
-
In this example, a vertically aligned SikaDamp sound dampening sheet is not wide enough to wrap the pipe.
If the sheet is not wide enough — if there's a gap in coverage — rotate the sheet 90° to better cover the pipe.
-
Without removing the protective backing, check the reoriented sound dampening sheet for fit by wrapping it around the pipe.
After determining the sheet fully covers the pipe, you may trim off any excess material using a scissors or knife.
Peel off the protective backing covering the adhesive. The sticky side will adhere to almost any clean surface.
Apply the sticky side of the SikaDamp 630 sheet to the pipe. Wrap the sheet around the pipe until it's covered.
Repeat the proceedure using additional sheets until the pipe is covered top to bottom. It couldn't be easier!